DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 18 Jul 2019, 19:42

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
 Post subject: introduction
PostPosted: 05 Jul 2019, 02:52 
Offline

Joined: 03 Jul 2019, 10:36
Posts: 4
Hi all Eamonn from Ireland here and thanks for having me on this forum. I've been visiting as a guest for a few months and now I might have a little more time
I hope to get down to building something. The plan is to have a complete new system (DAC, amp and speakers) that I'll put together in stages. I don't have that much experience in DIY audio. My brother and I built a stereo (Wharfdale speakers and Texan amp) over forty years ago when I was a teenager but on that project I filled the role of sidekick. I'm looking forward to getting back to a bit of DIY after a long break.


Top
 Profile  
 
 Post subject: Re: introduction
PostPosted: 06 Jul 2019, 21:49 
Offline
Project Author
User avatar

Joined: 04 Jun 2008, 20:59
Posts: 3987
Location: Arizona, USA
Hi and welcome to the forums. When you figure out what you would like to build, ask and I'm sure someone has some ideas on where to begin. Lots of friendly folks will assist you in getting it right as well.

Good listening
Bruce

_________________
Some of my DIY Tube Amplifier Projects:


Top
 Profile  
 
 Post subject: Re: introduction
PostPosted: 09 Jul 2019, 18:02 
Offline

Joined: 03 Jul 2019, 10:36
Posts: 4
Thanks Bruce, I have an idea in mind so I may as well throw it out there and see what people think
Eamonn.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 5 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© diyAudioProjects.com - Terms of Service - Privacy Policy