DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 16 May 2021, 01:23

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 12 posts ]  Go to page Previous  1, 2
Author Message
PostPosted: 02 May 2021, 18:47 
Offline

Joined: 15 Mar 2021, 21:11
Posts: 6
Attachment:
Potentiometer.PNG
Attachment:
5_1_21 Blog approximation of my work.pdf
Study the new way that I will build the amplifier after your comments. I'm eliminating the resistor and the capacitor between pins 1 and 8 producing a gain of 20 which is that set internally by the IC according to the author of the blog. He doesn't show your 100 uF capacitor in parallel (?) to the power and pin 6. Like you he shows a Zobel network. The in series capacitor to the speaker has a value of 250 uF instead of your 470 uF. The in parallel volume resistor with a value of 20 kOhm between the audio input and pin 3 looks like what? The PNG file that I attached? Because it has an unusual schematic symbol and both of you agree that it controls volume. On your recommendation I'll use a 470 uF capacitor in series with the Audio Out section for better bass. Also since the 9 volt battery is acceptable, I'm using just that with a 100 uF capacitor in parallel. Pin 7 (Bypass) is non-essential so I'm ignoring it or if need be I'll connect a 0.1 uF capacitor.


This post has a file attachment. Please login or register to access it. Only Registered Members may view attached files.



Top
 Profile  
 
PostPosted: 03 May 2021, 12:36 
Offline
Project Author
User avatar

Joined: 06 Apr 2009, 10:08
Posts: 1748
Location: US Pacific Northwest
Yes. That is the minimum parts layout as detailed in the LM386 data sheet. It will work just fine.

_________________
Matt
It's all about the Glass!
http://www.CascadeTubes.com
Cascade Tubes Blog


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 12 posts ]  Go to page Previous  1, 2

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 5 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© diyAudioProjects.com - Terms of Service - Privacy Policy