DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 08 May 2021, 19:37

All times are UTC - 6 hours [ DST ]

Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Induction
PostPosted: 04 Jun 2016, 16:25 

Joined: 03 Jun 2016, 19:26
Posts: 1
Howdy ya'll. I'm new here and this is my first post. I have a new Yamaha surround pre/pro and plan on using all the channels.
Yamaha specifies a presence speaker height of 69 inches front and rear. I plan on making my own speaker stands out of old disc brake rotors and one inch black pipe. I'm thinking about drilling a hole in the pipe at the bottom and top, beveling it to prevent snags, and running the wire (12 gauge) through the pipe.
Should I have any concerns about induction and frequency problems?
If so, is there a way to negate it?

 Post subject: Re: Induction
PostPosted: 04 Jun 2016, 20:55 
Project Author
User avatar

Joined: 04 Jun 2008, 20:59
Posts: 4364
Location: Arizona, USA
Hi, I'm sure someone will holler. But I doubt that there will be enough to matter. I would probably twist the wire though. It is common practice to run speaker wires through holes in the supports of commercial stands and I have never heard of any issues.

Good listening

Some of my DIY Tube Amplifier Projects:

Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 6 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 3 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© - Terms of Service - Privacy Policy