DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 21 May 2019, 17:09

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 1 post ] 
Author Message
 Post subject: AC voltage output clamp
PostPosted: 17 May 2019, 09:54 
Offline
User avatar

Joined: 01 Jun 2013, 09:05
Posts: 699
Sorry for the repeat post.
I asked this question in a thread, however I thought some input from SS and all members might be interesting.
I.e. what's the effect of a Zener clamp in non-conduction.

A quick question,

Has anyone had any experience with voltage clamping the output on the M7 circuit.
Its a simple idea using Zener's shock horror shown here:
http://sound.whsites.net/project167.htm
The reason I ask is the M7 circuit with output fed via a capacitor from the anode of the driver tube.
Obviously if the cap fails then its B+ on the output, which "maybe" why the circuit changed.

However that is not an issue if its clamped sinking the voltage in the 50K (2X 2Watt100K in parallel) anode load in fault condition.

Zener's are noisy in conduction but in no conduction situations? looking at the junction capacitance maybe.
Its obvious that the way to go is a self healing capacitor but that defeats the point when I'm looking at oil/ foil caps etc.
NB there were problems in the past with some old Jensen caps failing.
There are other ideas using neon's in non conduction etc.
So any thoughts would be interesting.

Regards
M. Gregg

_________________
What is the sound of one hand clapping?


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© diyAudioProjects.com - Terms of Service - Privacy Policy