DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 20 Sep 2018, 16:23

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: 23 Mar 2018, 05:51 
Offline

Joined: 23 Mar 2018, 05:39
Posts: 2
Hey folks, first post (introduction will be my next post lol)
Id like to build an entire system and have spent quite a while scouring the interwebs. Irs not been that easy to find complete projects i like.

Can you throw some recommendations my way for scratch built pre-amp and amp projects for about 25 watts a channel that include a pcb layout aswell if possible with some reasons for the recommendation. Through hole and basically SMD are fine as is having to etch the pcb if non are available to buy.

Id prefer class D or AB amps if possible.
Interested to see what's thrown in for ideas as most everything i was interested in like the silicon chip studio series pre-amp and the elektor 2012 pre-amp arent rated very well by you guys lol

Thanks in advance.
Regards
Jim


Top
 Profile  
 
PostPosted: 10 Apr 2018, 21:11 
Offline
Project Author
User avatar

Joined: 04 Jun 2008, 20:59
Posts: 3786
Location: Arizona, USA
Hi, Use any of the "chip" amps. I like the LM3886T version as it is trouble free, there are lots of circuits for it, they are cheap, and the T version is insulated from the tab so you can mount it on nearly anything.

Good listening
Bruce

_________________
Some of my DIY Tube Amplifier Projects:


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 4 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© diyAudioProjects.com - Terms of Service - Privacy Policy