DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 18 Mar 2019, 09:35

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 652 posts ]  Go to page Previous  1 ... 62, 63, 64, 65, 66
Author Message
PostPosted: 11 Mar 2019, 17:43 
Offline

Joined: 23 Feb 2017, 02:02
Posts: 361
This suggest that the 1k feedback makes the effective impedance accross 680ohms smaller and could be cutting off earier than 2.3hz
https://www.electronicproducts.com/RC_F ... lator.aspx

If you make the 100uF bypass to 220uF or 330uF that could solve the plorbem but is only a guess.


Top
 Profile  
 
PostPosted: 12 Mar 2019, 08:57 
Offline
Project Author
User avatar

Joined: 04 Jun 2008, 20:59
Posts: 3932
Location: Arizona, USA
Hi, Unless you have really unusual speakers the NHB is sort of optional. All of these amps I have measured respond flat to about 8 HZ with it in place. Since it is there to stop potential resonance issues that could possibly occur in the range of 75KHZ with peculiar loads you can leave it disconnected. In the bigger amps I routinely (and in the kits) include a NFB defeat switch. Some folks like the sound better. You can increase the cap if you want. My data indicates that 100uf is more than adequate for flat response belows 20HZ . Try increasing it. If you like the result, great, that is what DIY is all about.

Good listening
Bruce

_________________
Some of my DIY Tube Amplifier Projects:


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 652 posts ]  Go to page Previous  1 ... 62, 63, 64, 65, 66

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 16 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© diyAudioProjects.com - Terms of Service - Privacy Policy