DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 17 Mar 2018, 21:02

All times are UTC - 6 hours [ DST ]

Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: 06 Mar 2018, 18:08 

Joined: 04 Mar 2018, 23:52
Posts: 2
I'm new to this forum. I entered because I wanted to find out which amplifier kit to buy with reasonable results. My last kit was from Heathkit in the early 80s and was a very sturdy computer with a few accessories as a printer and floppy drive. So I had to dust off my soldering iron.

I ordered a K-16LS and a phono amp from s5 electronics and put it together according to the instructions. It is mounted on the supplied piece of poplar board but I will make a wooden/aluminium case for it.

When I make the case, parts have to be rearranged. I suppose I have to connect the RCA-connectors with screened cable. I also suppose I need a DPDT switch for switching between CD/cassette player and turntable. This switch will be connected to where the 3-pin jumpers are.

The ceramic sockets will stick through the aluminium plate. Is it abvicable to drill a circle of small vent holes around the sockets to improve cooling?


This post has a file attachment. Please login or register to access it. Only Registered Members may view attached files.

PostPosted: 11 Mar 2018, 21:52 
User avatar

Joined: 28 May 2008, 21:53
Posts: 4535
Location: Winnipeg, CANADA
The vent holes will help with cooling and I would suggest them. The K-8 amps ran on the hot side. How warm does that power transformer get?

[ DIY Mains AC Power Cable Cord ] - [ Gobo LM1875 Amp Kit ] - [ Tang Band D4-1 Horn Speaker Kit ] - [ Monoblock Push-Pull KT88 Tube Amp Kit ]

Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 6 hours [ DST ]

Who is online

Users browsing this forum: Google Adsense [Bot], mtlsir and 13 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© - Terms of Service - Privacy Policy