DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 17 Mar 2018, 13:16

All times are UTC - 6 hours [ DST ]

Post new topic Reply to topic  [ 1 post ] 
Author Message
 Post subject: LM4752 chip amp
PostPosted: 06 Mar 2018, 13:12 

Joined: 06 Mar 2018, 12:36
Posts: 1
Hello all,

This is a first time post. I am working on the spec of a chip amp for a compact stereo system based on the Texas Instruments LM4752 op-amp. The objective is to have an absolute minimum number of components in the whole system.

The amp circuit would be based exactly on the schematic specified in the LM4752 datasheet.

So far the spec includes:

TI LM4752 op-amp (7W output per channel to 8Ω speakers)
Fostex FF105WK speakers (10W rated input)
Hammond 1182K12 toroid power transformer ... power/1182

For a basic power/rectifier supply:

The secondary windings on the Hammond coil would be connected in series for 24V output
Capacitor value for power supply?
Resistor value for power supply?
Can a diode rectifier “pack” be used, or is there an advantage to using discrete diodes? Any recommendations for such diode pack?
Is there a problem with putting the powe supply diodes/capacitor/resistor on the same board as the amp?

I'd appreciate any comments/suggestions.


Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 6 hours [ DST ]

Who is online

Users browsing this forum: Google Adsense [Bot] and 10 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© - Terms of Service - Privacy Policy