DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 21 Jan 2021, 09:45

All times are UTC - 6 hours [ DST ]

Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: 05 Mar 2017, 01:39 

Joined: 05 Feb 2017, 00:48
Posts: 1
hi got myself a Naim NAP 200 clone kit from ali express. can someone help me with the wiring diagram and bias current settings for optimum performance please?
any tips and hints on getting the most out of this awesome amplifier would be welcome

PostPosted: 06 Mar 2017, 19:12 

Joined: 23 Feb 2017, 02:02
Posts: 677
Bascally you see the speaker sign and R and L.
The speaker sign means the speaker output black means ground and red means positive ... 83417.html

You see the R L for the input audio
blue is R in
Green Is input ground
Red is L in

You have the yellow set and blue set with 28v. You supply it with two sepearate sets of 28V ac supply.

For the Bias setting you want to monitor the temp of your heat sink and slowly increacse your bias from low to high. Bascally more bias means better sound but it runs hottter and setting it too high may ruin your ampflier.
Professionally speaking you should also monitor your current input, so if the current goes super high suddendly then you should turn off.

You can tell by the demo picture with the small heat sinks this amp looks like a class B ampflifier more than a class A, the pots on the board may be for adjusting DC voltage at speakers to zero instead of adjusting the bias

Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 6 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 7 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© - Terms of Service - Privacy Policy