DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 19 Jul 2019, 04:10

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 12 posts ]  Go to page Previous  1, 2
Author Message
PostPosted: 26 Sep 2012, 17:57 
Offline
Project Author
User avatar

Joined: 06 Jun 2008, 18:23
Posts: 5115
Location: Australia
Gio wrote:
A while back I was using a Behringer SRC2496 I found the same thing. Upsampling improved the sound in all cases. in particular, I found that upsampling sounded best when you upsample in whole number multiples. For example, a 16 bit / 44.1 kHz CD sounded best at 24 bit / 88.2 kHz, not 96kHz.

When converting the files with Switch I'm not sure a get that choice but I will have a look.

_________________
Projects:"retro2308" - chip based headphone amp | ”Calibre 834” - tube phono MM preamp | ”najah” - Raw 180W Tripath Class D power amp | "Icon" - Shuguang CV-181Z preamp


Top
 Profile  
 
PostPosted: 26 Sep 2012, 21:38 
Offline
Project Author
User avatar

Joined: 04 Jun 2008, 20:59
Posts: 3987
Location: Arizona, USA
Hi Gio and Mark, that is usually the case. The DAC doesn't have to interpolate data bits, just multiply them in integer amounts. I believe that there is a link on the audioroundtable or vinylengine forum that goes into considerable detail on this subject. If I can find it I post it here. The process would seem simple, but the implementation is not.

Good listening
Bruce

_________________
Some of my DIY Tube Amplifier Projects:


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 12 posts ]  Go to page Previous  1, 2

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 0 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© diyAudioProjects.com - Terms of Service - Privacy Policy