DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 19 Mar 2019, 02:04

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 21 posts ]  Go to page Previous  1, 2, 3
Author Message
PostPosted: 29 Aug 2009, 21:52 
Offline
Project Author
User avatar

Joined: 14 Oct 2008, 17:35
Posts: 901
Location: Dartmouth, Nova Scotia
So than Gio, I'm guessing that the 340-340 volt Harman Kardan transformer shown in the first picture won't be to much for the power supply? I seem to have this problem with every project where I reuse old parts, the voltages are ither too high or too low, and the transformer with the perfect voltage is ither too small or too massive to be worth using. :)

I think 428V will be what will come out plus there is voltage drop in the choke, but I am not good at predicting the exact voltage of a power supply other than what comes out of the calculator. I suppose it couldn't be any worse than the original supply, but I do like to keep atleast a 100V below the maximum ratings of components in a high voltage supply becuase there is also lots of heat produced from the tubes in a confined preamp like this.

Right at this momment from as far as I can tell, every thing is working no flaws in both my phono stage or power supply! :D Other than the fact that I did the test of a 50V transformer, which sadly only got me 24V at the supply output but it was good enough to be sure there were no shorts or miswiring, and even more promosing was the fact that I got music to play (barely).

I have lots of pictures so keep whatching! ;)

_________________
My Mini 12AU7 Tube Preamp, Pioneer SX-D7000, JVC XL-V221BK, JBL L80T, DCM TF700


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 21 posts ]  Go to page Previous  1, 2, 3

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 16 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© diyAudioProjects.com - Terms of Service - Privacy Policy