DIY Audio Projects Forum
http://diyaudioprojects.com/Forum/

4S preamp project
http://diyaudioprojects.com/Forum/viewtopic.php?f=9&t=6392
Page 9 of 9

Author:  Gab [ 29 Mar 2019, 09:24 ]
Post subject:  Re: 4S preamp project

ILoveHiFi wrote:
In context it ment that the twisted pair listened to for comparison was a very expensive one, therefore its fancy


0.40$/foot

ILoveHiFi wrote:
Inside the amp the amp case is already ground, acting as some sheilding from external signals already.


This is why I grounded my shield to the case, so it is at the same ground potential as the case and have the same shielding abilities. The goal was to protect my input wires inside the amp from picking up noise or something like that. I wasn’t worried about external signals... I guess that it’s not what caused my problem since it had no effect on the hum whatsoever.

Page 9 of 9 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/