DIY Audio Projects Forum
http://diyaudioprojects.com/Forum/

K-16LS amplifier with phono amp
http://diyaudioprojects.com/Forum/viewtopic.php?f=9&t=6164
Page 1 of 1

Author:  wr1944 [ 06 Mar 2018, 18:08 ]
Post subject:  K-16LS amplifier with phono amp

I'm new to this forum. I entered because I wanted to find out which amplifier kit to buy with reasonable results. My last kit was from Heathkit in the early 80s and was a very sturdy computer with a few accessories as a printer and floppy drive. So I had to dust off my soldering iron.

I ordered a K-16LS and a phono amp from s5 electronics and put it together according to the instructions. It is mounted on the supplied piece of poplar board but I will make a wooden/aluminium case for it.

When I make the case, parts have to be rearranged. I suppose I have to connect the RCA-connectors with screened cable. I also suppose I need a DPDT switch for switching between CD/cassette player and turntable. This switch will be connected to where the 3-pin jumpers are.

The ceramic sockets will stick through the aluminium plate. Is it abvicable to drill a circle of small vent holes around the sockets to improve cooling?

Attachment:
P1010125q.jpg

Author:  Gio [ 11 Mar 2018, 21:52 ]
Post subject:  Re: K-16LS amplifier with phono amp

The vent holes will help with cooling and I would suggest them. The K-8 amps ran on the hot side. How warm does that power transformer get?

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/