DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 30 Oct 2020, 09:06

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: 300b mesh plate tubes
PostPosted: 22 Jan 2013, 11:36 
Offline

Joined: 11 Oct 2011, 19:39
Posts: 195
Has anyone done a comparison between the 300b mesh plate tubes and standard solid plate? The reason that I ask this is that I am looking to design a 300b set and want to use the AZ1 rectifier tube. Aesthetically using a mesh plate rectifier along with a mesh plate 300b would look stunning, however I don't want to invest over 400 bucks in output tubes if they will perform sub-par compared to solid plate tubes.

I know that suncalc has a thread for the design of a 300b set, but I didn't want to introduce this topic there so as to keep his thread completely on topic.

If someone has done the comparison, what was your over all impression and with what style of music did you use for the listening test?

Thanks in advance.


Top
 Profile  
 
PostPosted: 12 Feb 2013, 09:37 
Offline

Joined: 10 Feb 2013, 20:27
Posts: 2
As my friend said, it won't be better than the other types.
As for these Chinese made 300Bs,try to find the earlier types could sound better.
If you want to know more about it, I have to ask him again.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: Majestic-12 [Bot], Minarai and 18 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© diyAudioProjects.com - Terms of Service - Privacy Policy