DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 21 Nov 2017, 01:23

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
 Post subject: Chassis Fabricators
PostPosted: 26 Sep 2016, 21:41 
Offline
Project Author
User avatar

Joined: 04 Jun 2008, 20:59
Posts: 3462
Location: Arizona, USA
Hi folks a question from my commercial side (not selling...asking info). Does anyone have a source (company) that will do steel chassis fabrication. The company we have been using is becoming difficult to deal with and is slowing us down. Typical requests are for between 10 and 25 chassis at a time. We have cad drawings and often request the same products (as our stock runs down). Depending on the model, a chassis might have welded corners, welded standoffs, tapped holes, several punch outs, powder coating and lettering. If someone knows a source please let me know.

Good listening
Bruce

_________________
Some of my DIY Tube Amplifier Projects:


Top
 Profile  
 
 Post subject: Re: Chassis Fabricators
PostPosted: 28 Sep 2016, 14:32 
Offline
User avatar

Joined: 05 Aug 2016, 14:35
Posts: 214
You are still in Arizona, and you wish to source locally?

http://www.yellowpages.com/phoenix-az/s ... abricators

I would start with the BBB A+ fabricators, first.


Top
 Profile  
 
 Post subject: Re: Chassis Fabricators
PostPosted: 28 Sep 2016, 20:37 
Offline
User avatar

Joined: 08 Aug 2009, 03:11
Posts: 2098
Location: Chilliwack, BC
Hope you have better luck!

I tried to source local and got a thousand excuses why they couldn't make a plain, rectangular aluminum box. I said "#$%^ 'em" and headed to China and never looked back :censored:

BlackBerry came to the same conclusion, today.

_________________
-= Gregg =-
* Ratings are for transistors - tubes have guidelines*
Home: GeeK ZonE
Work: Classic Valve Design


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
cron
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© diyAudioProjects.com - Terms of Service - Privacy Policy