DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 24 May 2018, 14:05

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: 04 Feb 2018, 14:28 
Offline
User avatar

Joined: 08 Aug 2009, 03:11
Posts: 2208
Location: Chilliwack, BC
Hi Folks,

Got a tuner here I believe the LC7207 is shot, but am hoping for an alternative to handing it back declared a boat anchor.

It came in with "manual" working OK, along with the FM memories, but no AM memory.

I replaced the rechargeable batteries (yes, they're good) and recapped it. Same problem.

I let it run for a few days, turned it off, then on... now no memories worked, but manual was fine.

Put it on the back burner for a bit (still running to keep the batteries chareged), but then upon switching from AM to FM again, FM locked up at 189.3 MHz and won't budge. No manual, no nothing.

I can even unplug all but the power wired to the board and it's locked at 189.3. I'd expect it to show zero when I did that as the frequency counter gets no input.

So, given it's a stupid P-MOS with unprotected gates (full ESD protocols were in place at the bench), I'm assuming it's the aforementioned unicorn-7207 :confused:

After much Googling, seems this happened only one other time, but everyone was stuck on changing the batteries (which he did, to no avail).

Cheers!

_________________
-= Gregg =-
* Ratings are for transistors - tubes have guidelines*
Home: GeeK ZonE
Work: Classic Valve Design


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© diyAudioProjects.com - Terms of Service - Privacy Policy