DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 25 May 2020, 01:21

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
PostPosted: 20 Feb 2015, 18:05 
Offline

Joined: 20 Feb 2015, 17:55
Posts: 2
Hi Ive never repaired an amp before Sound from one side is very fuzzy Could it be a bad solder I would like some help before i start ripping things apart thanks


Top
 Profile  
 
PostPosted: 21 Feb 2015, 23:41 
Offline

Joined: 26 Oct 2012, 21:00
Posts: 201
Location: ontario canada
if you've never repaired an amp before you probably don't have test equipment so how do expect to trace out a distortion problem? and that's not dismissing the possibility that it's a bad solder joint.
assumptions about the cause and nature of a fault without the right methodology can lead you down the proverbial "garden path" or that other saying 'bout "a creek and a paddle"
a quick check for a bad solder would be "the circuit disturbance test"


Top
 Profile  
 
PostPosted: 22 Feb 2015, 02:19 
Offline
User avatar

Joined: 08 Aug 2009, 03:11
Posts: 2229
Location: Chilliwack, BC
Does the sound clear up a bit when you shock it with some volume? If so, a bum speaker protection relay is likely to blame.

A good cleanup of the switches with contact cleaner and pots with Nu-Trol or equivalent also solves a lot of problems.

_________________
-= Gregg =-
* Ratings are for transistors - tubes have guidelines*
Home: GeeK ZonE
Work: Classic Valve Design


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© diyAudioProjects.com - Terms of Service - Privacy Policy