DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 03 Apr 2020, 23:15

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: 22 Mar 2014, 10:10 
Offline

Joined: 09 Mar 2014, 16:39
Posts: 9
I am new here and would like some advice and help making a decision,I have 2 subwoofers I built with boston 10" drivers in a daul 10" enclosure.I have no information on the drivers other than they are 6 ohm and measure in at 5.2 ohms.instead of doing a passive crossover I want to get a amp with crossover biult in like the Inuke series from behringer.my question is can I do both subwoofers with the inuke 1000dsp,I know it has bi amp capabilities wich I will use later to drive a sub and a BIC fh6 lcr speaker.oh and the sub is 2 ohms wired in parrelel,one of the main reasons for looking at this type of amp.the plate amps dont do below 4 ohms.

but for now I want to use the inuke for the 2 subs.Can I use the inuke to drive both subs using channel 1 and 2 as a low pass channel?I have looked at the manual and I think I can But If I could get some verification and clarification on how to do it I would appreciate it.Inuke seems the best choice for this for the price I am willing to pay(200-300) I will also take recomendations on other simular amps in that range I see Crown,QSC and others but have not studied as I have the Inuke.Thank You,Cleon


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© diyAudioProjects.com - Terms of Service - Privacy Policy