DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 25 May 2020, 00:57

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: 17 Jan 2014, 12:56 
Offline

Joined: 17 Jan 2014, 12:46
Posts: 1
Hey,

I'm a software engineer with an occasional interest in hardware design and development. Music-wise I'm into lo-fi, EDM and 8bit mostly.. :)

I know my analog electronics reasonably well, and know some good sources to go looking when I need to augment my knowledge. What I'm lacking bitterly is knowledge of audio industry specifics, such as line levels, best practices for audio amplifier design, what the output should look like if it's going to be plugged into a guitar amp's input, and what if it will be plugged into an effect processor or mixing table, what the output impedance and peak-to-peak voltage should be, etc.

Could anyone point me to a good book or online resource that details stuff like this? My searches online have mostly landed me on tutorials about Ohm's law and soldering technique. :D


Top
 Profile  
 
PostPosted: 17 Jan 2014, 19:20 
Offline
User avatar

Joined: 08 Aug 2009, 03:11
Posts: 2229
Location: Chilliwack, BC
Hi, welcome!

I just downloaded this and it's chocked full of goodness:
https://bgaudioclub.org/uploads/docs/Au ... ifiers.pdf

This search can help find more:
http://www.google.com/search?q=designin ... unofficial

Cheers!

_________________
-= Gregg =-
* Ratings are for transistors - tubes have guidelines*
Home: GeeK ZonE
Work: Classic Valve Design


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© diyAudioProjects.com - Terms of Service - Privacy Policy