DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 16 Dec 2018, 13:55

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Newbie Set-Up Advice
PostPosted: 26 Jan 2011, 15:22 
Offline

Joined: 26 Jan 2011, 14:41
Posts: 1
Very excited about this site! I'm somewhat a HiFi newbie and want to solicit some suggestions upgrading my set-up and which DIY project I should take on.

What I have:
- HK 3485 Stereo Receiver
- Audio-Technica PL120 Turntable
- JBL Venue Series Balcony Speakers
- Mac/iPod (music is mostly lossless but not above 16bit or anything fancy)

It's not a great system, but no component has been disappointing considering their price-points. The HK Receiver is better than expected. I'd much prefer the simplicity/design on an integrated amp, but I use the tuner a lot and its sound is far better than I expected. My only complaints is that the soundstage/imaging is a little small (doesn't have that, "holy crap they're in the room right now" vibe).

- I'm inclined to keep the HK Receiver because I'm sure I'll get more for my money in other areas.
- I will be replacing the turntable and speakers (a discussion for another time). Note: the phono input to the HK Receiver is pretty decent and I'm inclined to keep that direct.
- I THINK I would like to invest in a DAC and/or a Tube preamp for the digital source. This is not only an attempt to get better sound from my main music source, but also an excuse for a tube DIY project!

Will a tube pre-amp actually make a decent difference? Is there any problem putting a preamp into the HK Receiver (or must it be a passive preamp)? Should I bother with a DAC? Or would I be altogether better off making a tube amp (I can still use the HK as a preamp)?

I hope these newbie posts aren't annoying, just trying to get started. Thanks for any advice!


Top
 Profile  
 
 Post subject: Re: Newbie Set-Up Advice
PostPosted: 30 Jan 2011, 21:11 
Offline
Editor
User avatar

Joined: 28 May 2008, 21:53
Posts: 4575
Location: Winnipeg, CANADA
Welcome to the forum.

Do you have experience with building tube gear?

My suggestion was going to be a phono stage kit. ;) With that config I would lean towards a DAC, particularly if you are using analogue signal from the iPod/Mac.

Cheers

_________________
[ DIY Mains AC Power Cable Cord ] - [ Gobo LM1875 Amp Kit ] - [ Tang Band D4-1 Horn Speaker Kit ] - [ Monoblock Push-Pull KT88 Tube Amp Kit ]


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© diyAudioProjects.com - Terms of Service - Privacy Policy