DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 18 Oct 2017, 11:41

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 1 post ] 
Author Message
 Post subject: SAE MK31 Service Tip
PostPosted: 31 Dec 2016, 03:40 
Offline
User avatar

Joined: 08 Aug 2009, 03:11
Posts: 2057
Location: Chilliwack, BC
A pesky thing about these and others is the "SAE 402" chip. It's a CA3086 and there is absolutely no replacement, other than discrete.

Fortunately as the specs show, they're basically a quintet of 2N3904's. The arrangement of the chip pins are as shown in the schematic below (the SAE schematic doesn't tell the whole story, you have to follow the traces).

You can put the transistors on a little perfboard (make them all equal height!) and mount it transistor-side against the heatsink with some thermal goop. Then three wires is all that's needed to a 14-pin DIP header to the pins indicated on the schematic.

The old chip is in physical contact with the heatsink. So you'll have to bend the three used header pins over, trim the rest, then insulate with epoxy, lest it shorts out.

Depending on the hfe of the matched-up 3904's, you may need to make the bias pot bigger... eith with a 500R unit, or just cut a trace and add a 150 ohm resistor. This will allow you to obtain the base-to-base recommended bias of 2V1.

The output transistors don't cross well, but ON Semi MJ11021G and MJ11022G are the drop-in replacement darlingtons.

(I'm putting these service tips here as it's the only forum I go to anymore with a SS section and my own forum is completely cloaked from search engines - and this info needs to get out there, as it doesn't exist!)

Cheers!


This post has a file attachment. Please login or register to access it. Only Registered Members may view attached files.


_________________
-= Gregg =-
* Ratings are for transistors - tubes have guidelines*
Home: GeeK ZonE
Work: Classic Valve Design


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© diyAudioProjects.com - Terms of Service - Privacy Policy