|DIY Audio Projects Forum
|connectors with wires
|Page 1 of 1|
|Author:||Hawkcigar [ 10 Aug 2019, 21:33 ]|
|Post subject:||connectors with wires|
Heyl everyone, I see amplifier boards and bluetooth boards with connectors attached to them. They look to be the female end of a connector and there should be a male connector with wires attached. Unfortunately, I never see the other side of the connector with the wires. Does anyone have a source or recommendation to purchase the other part of those connectors? Thanks for the patience with an obviously newb question!
|Author:||Cliffystones [ 10 Jan 2020, 12:16 ]|
|Post subject:||Re: connectors with wires|
Some of the BT modules from China come with "Pigtail" cables with the plug on one end and bare wires at the other. I have found some with thru-hole solder pads as well. If the pigtails are not provided you may have to by the crimp terminals, crimp tool and pin housings to make your own, but the crimpers could force you into bankruptcy. One thing I've done is un-solder the pins on these and solder wire pigtails directly to the board.
|Page 1 of 1||All times are UTC - 6 hours [ DST ]|
|Powered by phpBB® Forum Software © phpBB Group