DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 14 Nov 2019, 10:17

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Newbee ?uestion
PostPosted: 28 Jan 2019, 16:59 
Offline

Joined: 23 Oct 2018, 21:47
Posts: 8
I have two ancient cabinets which contain a 15 ohm horn (pressure unit) and a 15 ohm woofer each. All, including the crossover unit, are in great shape cosmetically, and functionally, as far as I can tell. What should my concerns be when obtaining an amplifier, in regard to power, type, ....something that would go easy on these speakers. They are incredibly loud, but I don't need to run them like that. My minuscule knowledge about electronics leads me ask if a tube amp would match up better. What ohm stat should I have in mind when looking for an amp?

I just need a little direction here. I don't want to investigate in the wrong direction.

Any help is appreciated.


Top
 Profile  
 
 Post subject: Re: Newbee ?uestion
PostPosted: 29 Jan 2019, 17:05 
Offline
Project Author
User avatar

Joined: 04 Jun 2008, 20:59
Posts: 4046
Location: Arizona, USA
Hi, What brand are the speakers, if not the enclosures at least the speakers themselves. From your basic description they could be Altec Lansing, Klipsch or JBL. If so the sensitivity would be quite high and thus you would only need a very modest amount of power to drive them. A tube amp would probably be quite suitable. You would need one with 16 ohm output though. Most will have that, but not all so you would need to verify that before obtaining one.

Good listening
Bruce

_________________
Some of my DIY Tube Amplifier Projects:


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© diyAudioProjects.com - Terms of Service - Privacy Policy