DIY Audio Projects Forum

DOD Mixer Power
Page 1 of 1

Author:  jobyscott [ 26 Feb 2018, 11:40 ]
Post subject:  DOD Mixer Power

Good morning all, I have a old DOD 1220 RM mixer that doesn't have a power supply. I am having trouble finding a new one. The power requirement listed on the back is (34 Volt ~ CT 50/60 Hz 1 Amp). It is also a 5 pin DIN connector. DOD sent me the schematic which I am attaching here. If someone could help me find a replacement or point me in the right direction as far as building one, it would be greatly appreciated.

Author:  Geek [ 26 Feb 2018, 15:07 ]
Post subject:  Re: DOD Mixer Power

36VCT is the closest standard voltage. It'll be fine with that.


Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group