DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 24 Mar 2019, 09:38

All times are UTC - 6 hours [ DST ]

Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Small mixer, preamp
PostPosted: 28 Mar 2018, 08:27 

Joined: 28 Mar 2018, 08:15
Posts: 1
I have limited knowledge of electrical components but can handle a soldering iron relatively well.
I would would like to build myself a mixer as described below but do not know what components to use or how to wire them up to get the desired result. Any help would be appreciated.
I want a small mixer with two 6.3mm inputs and two 6.3mm outputs.
Input 1 and 2 needs to go through a pre-amp and have individual volume controls. from there they need to go to output 1.
Output 2 should be only the signal from Input 2 before the preamp (a bypass).
I would also like to be able to run this of either a battery or a DC supply.
I would also like a on/off switch and an LED power light.
I have been searching for something like this for days now and could not find anything.
Any advice will be greatly appreciated.

 Post subject: Re: Small mixer, preamp
PostPosted: 29 Mar 2018, 12:46 

Joined: 09 Oct 2012, 19:43
Posts: 334
Location: Vancouver Canada
Elliot has many projects for mixers etc. This will give you some ideas and help to fill in some blanks.

Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 6 hours [ DST ]

Who is online

Users browsing this forum: Majestic-12 [Bot] and 5 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© - Terms of Service - Privacy Policy