DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 19 Dec 2018, 05:43

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: 04 Feb 2018, 17:43 
Offline
Project Author
User avatar

Joined: 06 Jun 2008, 18:23
Posts: 4988
Location: Australia
Where I work we sell what we belive were motor start caps. There is some light industry around where I work and every now and then some one asks for a motor start cap. Theirs is usually bulging if not completely destroyed. Most times we can match the size usually about the 10uf mark. We have two types, metal can the black resin encased.

http://www.suntan.com.hk/pdf/Plastic-Film-Capacitors/TS11.pdf

It appears according to the site above whose caps we sell ours are motor run. I understand you can use motor run as motor starts but not always the other way around. I had purchased some from work years ago but didn't use them believing that were motor start and wouldn't handle constant voltages. We now know they are runs and I can use them . They are in bright shiny metal cans but I would stil, probably, spray them if to be displayed atop a tube amp.

The biggest is 30uf, perfect for most tube rectifiers as the first cap. Our list price is A$17. Not over expensive even if you used two.

_________________
Projects: "Grace" - Psvane 6SN7-SE Globe preamp | | "VoXUno" - Single driver MarkAudio 12P speaker | | "Lagoon Take 2" - Single stage tube preamp | Website: retro-thermionic


Top
 Profile  
 
PostPosted: 10 Feb 2018, 03:51 
Offline
Editor
User avatar

Joined: 28 May 2008, 21:53
Posts: 4575
Location: Winnipeg, CANADA
Hi Mark. These oil caps can as work well as part of a speaker crossover.

_________________
[ DIY Mains AC Power Cable Cord ] - [ Gobo LM1875 Amp Kit ] - [ Tang Band D4-1 Horn Speaker Kit ] - [ Monoblock Push-Pull KT88 Tube Amp Kit ]


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 4 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© diyAudioProjects.com - Terms of Service - Privacy Policy