DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 23 Jan 2018, 09:18

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: 19 Apr 2013, 16:27 
Offline

Joined: 13 Feb 2012, 13:32
Posts: 21
Location: Arizona, USA
Back on the topic interconnect cables...
I recently added a Yamaha Parametric EQ into my (formely) simple system to give it a try and like what I hear. My speakers ar Hammer Dynamics Super 12's and they needed a little help below 60 hz and this gives me just that and does not muck up the sound otherwise. The Equalizer is XLR balanced input and output. and the rest of my system is unbalanced.

I used some existing cables made of Belden 2 conductor shielded mic cable, but had to use two cable connected ent-to-end to make the EQ out to power amp link.

I would want to build up a new pair of cable to go from the output of the EQ into my Oddblock tube monoblock tube amplifiers to eliminate the extra length and connectors. Shoud I use star-quad cable (it seems to be unplated copper conductors with no mention of OFC or silver plating), or go with a conventional 2-conductor shielded cable that is OFC silver plated conductors? These cables will be about 4 feet long, and I plan to use good quality plugs.

Any advice will be appreciated.


Top
 Profile  
 
PostPosted: 20 Apr 2013, 08:40 
Offline
Editor
User avatar

Joined: 28 May 2008, 21:53
Posts: 4515
Location: Winnipeg, CANADA
Hi Bill,

Are you are looking to make a balanced to unbalanced cable? Can you post links to the wires you are looking at.

Cheers

_________________
[ DIY Mains AC Power Cable Cord ] - [ Gobo LM1875 Amp Kit ] - [ Tang Band D4-1 Horn Speaker Kit ] - [ Monoblock Push-Pull KT88 Tube Amp Kit ]


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© diyAudioProjects.com - Terms of Service - Privacy Policy