DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 19 Aug 2018, 10:36

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: 04 Apr 2017, 08:25 
Offline

Joined: 04 Apr 2017, 07:59
Posts: 1
Hi,

Total noob here with great ambitions and quite a lot of willpower to make this work :)

I'm planning on building a matrix mixer based on this circuitry: http://sound.whsites.net/project129.htm. (this will be an 8x8) and I'm adding a simple hadphone amp after the post mix filter (Figure 3 output leg).
What I would like to do is to have an option to get some type of connector where I can send the 8 buses over and the vcc, vee, ground over and can move the mixing pots and output amps to a different location (3 meters tops). Is there a connector type that I need to find, or I can use something that has enough pins, and should be careful with the cable selection or a mix of both. I rather not use a snake but something that's a single connector.

Is this ok, or I should be looking at making the outputs ballanced and transmit it that way?


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© diyAudioProjects.com - Terms of Service - Privacy Policy