DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 23 Sep 2018, 14:01

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Chassis Design
PostPosted: 02 Aug 2018, 18:35 
Offline

Joined: 23 Jul 2013, 16:27
Posts: 1
I'm building a Velleman P4005 based amp and am looking for some layout help. Do I need to wall off the amp (grounded metal) from the transformers and power supply? Are there any rules about most any aspect?

Thanks


Top
 Profile  
 
 Post subject: Re: Chassis Design
PostPosted: 29 Aug 2018, 09:06 
Offline
User avatar

Joined: 01 Jun 2013, 09:05
Posts: 670
Hello Alan,

The reason you have no answers is because the question is to vague.
It sounds like your asking !how do I build an amplifier.
you need to show some pictures of what you have and what kind of chassis you are thinking of building.
Give people some ideas what you are using it for and what you hope to get out of the project.
Ie wood chassis, metal chassis or combination of both.
What material you are using what transformers, capacitors and if the circuit is on a PCB or hard wired.

Draw a picture of your ideas of the internal build then people will comment in constructive way and say what's good and bad about it.
Where do you want to put controls and connectors.

Regards
M. Gregg

_________________
What is the sound of one hand clapping?


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© diyAudioProjects.com - Terms of Service - Privacy Policy