DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 22 Sep 2019, 08:05

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 12 posts ]  Go to page Previous  1, 2
Author Message
PostPosted: 13 Jan 2009, 16:30 
Offline
Project Author
User avatar

Joined: 14 Oct 2008, 17:35
Posts: 901
Location: Dartmouth, Nova Scotia
One of these days I am going to post my mods of the JVC.... damn camera cable is lost! :down:

I can use the output of my D/AC to drive my amplifier without any problems, I think allot of the opamp out put cd players can do the same as long as it is a voltage output, or wait is it current or voltage output types that can drive directly?

_________________
My Mini 12AU7 Tube Preamp, Pioneer SX-D7000, JVC XL-V221BK, JBL L80T, DCM TF700


Top
 Profile  
 
PostPosted: 11 Jul 2013, 11:35 
Offline

Joined: 11 Jul 2013, 10:24
Posts: 1
I have the same Denon CD deck, and would like to try my hand at upgrading the power supply and output caps. While I have decent soldering skills, my ability to interpret an electronic schematic is quite limited. Is there any way you could identify the location of the specific caps to be replaced? Perhaps by referencing the ID numbers stenciled on the circuit board? Thank you very much....I'm very curious as to whether I will hear the same improvements that you describe.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 12 posts ]  Go to page Previous  1, 2

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© diyAudioProjects.com - Terms of Service - Privacy Policy