DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 08 Mar 2021, 05:25

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: 03 Dec 2020, 03:28 
Offline

Joined: 03 Dec 2020, 03:21
Posts: 1
Hi,
Thanks for the acceptation on this forum. Im kinda new on this beautifull univers and i have some noob questions.

I wanna do a portable bluetooth speaker, made in wood like a lot are doing it.

But i have some questions about the speaker power/ ohm.

The board i plain to order is a bluetooth board TDA7498 , 100w each and accept 4 ohm until 8 ohm.

I wanna try to put 4 speaker in total, 2 full range, 2 tweeter and 1 passive for the bass ( or two )

Should i go for a 8 ohm one's or 4 ohm one's ? And if it's 100w by channel can i go for example 30w full range + 30w tweeter on each side ? Sorry for the noob's questions haha and thansk for your answers

I heared also that the voltage on battery is important and some told me to go 24v instead of 12v battery. The board accept 12v to 30v max.

Actually i have this in my card :

2x 30w 6 ohm tweeters
2x 20w 4 ohm Full-range speaker
2X passive radiator 120mm ( maybe too much ? )
1 x board TDA7498
1X 25.2v Panasonic 12000Mah battery.

And then i need to order power button for this.

If i connect everything together will it work ? I miss something ? Calcul aren't good ?

Sorry for all thoses noob questions but i wanna be sure to start with something good :)

Will it work


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 11 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© diyAudioProjects.com - Terms of Service - Privacy Policy