DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 18 Jul 2019, 07:28

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: T/S parameters error??
PostPosted: 10 Nov 2018, 09:31 
Offline

Joined: 10 Nov 2018, 09:29
Posts: 1
Hello lovely people!

I recently decided to try and measure T/S parameters for an undocumented loudspeaker as per this method:
http://sound.whsites.net/tsp.htm

However, when I use a calculator for a box it states it needs to be about 400 litres, which is impossibly large. Are my calculations off?

Speaker is 20W 4.5".

Re=7.6Ohm
Rs=8Ohm
Vs=1V
Fs=116Hz
Vm=0.169V
Im=0.021A
Rm=39.6Ohm
r0=2.5
Ir=0.033A
Vr=0.264V
Fl=102hZ
Fh=130hZ
Qms=6.55
Qes=2.01
Qts=1.54
Fs1=69Hz
M1=5grams
A=63.585
M=2.669
d = density of air = 0.001204 g/ml
c = speed of sound = 345 m/s
Cms=7.060187e-7
Vas=4.089lts

Thanks in advance.


Top
 Profile  
 
PostPosted: 13 Nov 2018, 21:12 
Offline
Editor
User avatar

Joined: 28 May 2008, 21:53
Posts: 4577
Location: Winnipeg, CANADA
Hello, welcome to the forum.

Qts=1.54 so these speakers are meant to be use open baffle, open back speakers. A high Qts would be common for car speakers and in the case of vintage speakers with an open back enclosure or in a radio/phono console. The speaker magnet on a high Qts driver will be small relative to the driver.

Hope this helps.

_________________
[ DIY Mains AC Power Cable Cord ] - [ Gobo LM1875 Amp Kit ] - [ Tang Band D4-1 Horn Speaker Kit ] - [ Monoblock Push-Pull KT88 Tube Amp Kit ]


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 4 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
cron
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© diyAudioProjects.com - Terms of Service - Privacy Policy