DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 20 Apr 2018, 09:49

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: 22 May 2017, 08:27 
Offline

Joined: 20 May 2017, 15:55
Posts: 1
Location: Houston Tx
Recently purchased four of these single, 3.5", 8 ohm, 110-20Khz drivers and want to place them in their own individual cabinets. Due to size constraints of where they're going, I'm looking at an interior space of roughly 190 cubic inches, with the cabinet looking like a small loaf of bread - 4.5" x 4.5" x 9.25" long. Would prefer to place the drive on the 4.5"x4.5" end.... so my question is, for optimal bass response, should I make these as a sealed cabinet [FYI - I'm not running a subwoofer] or should I port the cabinet ? If I port, what diameter and what length ? Also, if I port, should I place it on the far end of the cabinet, facing the opposite direction the driver, or should I place it along it's length, somewhere towards the bottom ? Any and all suggestions would be most appreciated.


Top
 Profile  
 
PostPosted: 22 May 2017, 15:23 
Offline
User avatar

Joined: 08 Aug 2009, 03:11
Posts: 2195
Location: Chilliwack, BC
Hi,

You'll find this handy:
http://www.ajdesigner.com/speaker/

Cheers!

_________________
-= Gregg =-
* Ratings are for transistors - tubes have guidelines*
Home: GeeK ZonE
Work: Classic Valve Design


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 5 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© diyAudioProjects.com - Terms of Service - Privacy Policy