DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 20 Apr 2018, 01:59

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: 28 Apr 2017, 07:16 
Offline

Joined: 28 Apr 2017, 06:02
Posts: 1
Anyone know of a resonant transmission-line type construction project for these speakers? Got 'em from my daddy who was an auction house junkie. They were in unopened factory boxes and I'd like to use them in a couple of T- L boxes. (I'm an amateur radio operator so quarter-wavelength anythings are fascinating fare). I'm told they were exceptionally good speakers for the time. I recently snagged a batch of TL1875 pwr. amp chips on Amazon so I'm chomping on the bit to fire up the solder iron and Skill-saw. Any help with speaker plans would be much appreciated.
Bill S. KF7OPR


Top
 Profile  
 
PostPosted: 22 May 2017, 20:08 
Offline

Joined: 26 Oct 2012, 21:00
Posts: 190
Location: ontario canada
the 755e would be more suited to an open baffle build or a large IB as it was originally a ceiling sound distribution speaker.
transmission line designs should not resonate there intent is to cancel the FS of the driver.
have you done a break in and measured resonance of your "mint in box" drivers?
i would be more inclined to try them in a backloaded horn and add a tweeter.

i'd also take a look at the Lansing Heritage Forum i recall a build recently featuring this driver.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 4 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© diyAudioProjects.com - Terms of Service - Privacy Policy