DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 05 Apr 2020, 19:22

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
 Post subject: Ribbon Tweeters
PostPosted: 19 Nov 2009, 10:02 
Offline

Joined: 24 Jul 2009, 12:17
Posts: 2
What in the opinion of the members would be the best way to connect two ribbon tweeters per channel , would it be best to use the same crossover for the tweeters or a seprate crossover for each tweeter or have you any other ideas that I may implement has I need to share the output from the amp equaly between both the tweeters,

Regards Electro


Top
 Profile  
 
 Post subject: Re: Ribbon Tweeters
PostPosted: 19 Nov 2009, 21:15 
Offline
User avatar

Joined: 08 Aug 2009, 03:11
Posts: 2229
Location: Chilliwack, BC
eletro wrote:
...connect two ribbon tweeters per channel...

Jeebus, do you need that much SPL on the top end? :shock:

What are your tweets?

Cheers!

_________________
-= Gregg =-
* Ratings are for transistors - tubes have guidelines*
Home: GeeK ZonE
Work: Classic Valve Design


Top
 Profile  
 
 Post subject: Re: Ribbon Tweeters
PostPosted: 03 Dec 2009, 09:47 
Offline
User avatar

Joined: 27 Sep 2009, 12:56
Posts: 42
Location: Montreal Canada
Also a ribbon tweeter drive a lot of power compare to other types. There's a transformer inside to convert the small resistance of the ribbon into 8 ohm. If you use a powerful amplifier it must not be a problem but at my knowledge you will need two mid-high crossovers to keep the correct impedance.

Regards.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 7 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© diyAudioProjects.com - Terms of Service - Privacy Policy