DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 10 Dec 2017, 21:21

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 42 posts ]  Go to page Previous  1, 2, 3, 4, 5
Author Message
PostPosted: 09 Oct 2017, 16:18 
Offline
Project Author
User avatar

Joined: 06 Jun 2008, 18:23
Posts: 4773
Location: Australia
At 90db effciency low wattage tube amps should drive that.

_________________
Projects: "Sanctum" - 12AU7 and 6AS7 direct coupled headphone amp | "retro-Oatley 6J6" - 6J6 push-pull headphone amp with OPTs | "Mimic Carbon" - carbon resistors and PIO caps. MM phono preamp
Website: retro-thermionic


Top
 Profile  
 
PostPosted: 29 Nov 2017, 09:03 
Offline
User avatar

Joined: 11 Aug 2016, 02:03
Posts: 28
Location: Bulgaria
A very underestimated moment - work with multilayer MDF!

There's still a lot of work on the stands.
I show you a few pictures of the front speaker bases, the rear speaker stands will look like the same;Always been a problem with the MDF, especially when we have a multilayer construction. Over time, individual parts are beginning to show up - all of this is the result of improper processing. Soon I will show you how to deal with this problem.


Always been a problem with the MDF, especially when we have a multilayer construction. Over time, individual parts are beginning to show up - all of this is the result of improper processing. Soon I will show you how to deal with this problem.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 42 posts ]  Go to page Previous  1, 2, 3, 4, 5

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: Yahoo [Bot] and 4 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© diyAudioProjects.com - Terms of Service - Privacy Policy