DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 17 Jul 2019, 02:40

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
 Post subject: stereo amplifier
PostPosted: 21 Mar 2019, 08:08 
Offline

Joined: 21 Mar 2019, 03:49
Posts: 1
Hello ! I am new here, I just wanted to know if I am at the right place to discuss my situation with a stereo amplifier that I made.
When I choose either, Left or right side, The output is good at a 4 Omhs speaker.
But when I choose both both side, I get this Hum and this Hum gets worse when I turn the volume'
I am not shure if this situation is a feed-back loop !
Please reply, to help me out with this !!!

here are the caracteristics.

I choose Tlo72 as a peamplifier, and then the medium power pramps (BD139-BD140) and then feed them in a push-pull transistors(2N3773; 2N6609) for power.





stardolphin.


Top
 Profile  
 
 Post subject: Re: stereo amplifier
PostPosted: 29 Mar 2019, 06:48 
Offline
User avatar

Joined: 05 Aug 2016, 14:35
Posts: 227
Hum loop, feedback loop, sagging power-supply, unshielded connections, could be so many things. Without schematics or pictures (preferably both) impossible to even suggest a direction or solution.


Top
 Profile  
 
 Post subject: Re: stereo amplifier
PostPosted: 29 Mar 2019, 07:24 
Offline

Joined: 23 Feb 2017, 02:02
Posts: 492
Did you design the schematic your self, with op amps and such high open loop gain either it runs or it dosen't run if you get anything wrong.
High feedback means its unlikley to humm if you designed correctly since feedback helps ignore noise.

However if your using the op amp for finite gain and everything with finite gain then your will have to be awwear of noise in the design.

I got the grounding and layout wrong when I was a rookie getting noise.
Layout you want to keep input signals away from transfomers and other sources of magetic field radations.
Ground you want to get things sorted and is not a few sentances explained.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© diyAudioProjects.com - Terms of Service - Privacy Policy