DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 28 Mar 2020, 13:55

All times are UTC - 6 hours [ DST ]

Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: 19 Oct 2017, 00:38 

Joined: 04 Apr 2015, 16:10
Posts: 3
i made it sounds well----tda 2050---i am using china made fake ic---i guess local made ic does not have protections---mmy speakers are cheap so not worried about them. ... Amplifier/

so i was thinking if amplifier fails in any case --is there any possibility it can destroy my pc analog signal output port or audio section ?

is there any easy method of security that can be given to protect my signal source devices as pc or mobile without signal strength loss ?

------------thank you

PostPosted: 19 Feb 2018, 14:59 

Joined: 09 Oct 2012, 19:43
Posts: 354
Location: Vancouver Canada
Yes there is a way. Use a speaker protection cct. It would monitor the output of the amp and if any DC appears on the line it fires (or relaxes) a relay. Normally the relay is in series with the spkr to protect it but if you instead use the relay contacts to disconnect the line out of your comp it would then do what you are after. Have a look on the net for spkr protection cct's that run on the voltage of your amp. That way you will not need a separate power supply for the protection cct.
Normally though this is not an issue as this line between the comp's sound card and input to the amp is high series impedance and would not due damage to your comp's card as the voltage from the amp would be dropped across it and not back up into your comp. Also finally (C1) will stop any DC from getting back from the amp into your comp's sound card.

Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 6 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 16 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© - Terms of Service - Privacy Policy