DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 16 Oct 2018, 01:57

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: 27 Jul 2016, 10:40 
Offline

Joined: 14 Apr 2016, 16:02
Posts: 53
Location: Argentina
Hi everyone! I Have a vintage Grundig R400 Amplifer that only works at 4 Ohms output (STK461) My speakers are 6 Ohms and output power is not an issue for me, but the protection fuses always blown up... The only way is to put 4 Ohms speakers? I know that the only issue in solid state amps is to not go under amp impedance but higher only decreases the output power and elevate distortion... that is true? or exist amps that only works in only one kind of impedance?

thanks!


Top
 Profile  
 
PostPosted: 27 Jul 2016, 12:44 
Offline
User avatar

Joined: 08 Aug 2009, 03:11
Posts: 2229
Location: Chilliwack, BC
You have a problem, then.

6 ohm speakers draw less current, not more. Fuses shouldn't blow.

Try a different set of speakers (6 or 8)... your 6 ohm ones may have pooched X-overs or a voice coil short.

Quote:
....vintage Grundig....

That was common for EU amps to demand one, low impedance (Siemens, Telefunken, Philips, B&O all did it at one point or another). Was a cheap way of getting more power by spending less deutchmarks on a power supply ;)

Cheers!

_________________
-= Gregg =-
* Ratings are for transistors - tubes have guidelines*
Home: GeeK ZonE
Work: Classic Valve Design


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 12 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© diyAudioProjects.com - Terms of Service - Privacy Policy