DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 22 Aug 2018, 02:30

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: 24 Apr 2016, 11:05 
Offline

Joined: 24 Apr 2016, 11:00
Posts: 1
Hi!

I have this surround receiver and it has started to behave a bit strange.
It started some time ago, it just did not start one evening, only the red power led was glowing on the front.
Opened up the amp and started to check for errors.
I checked the voltage to the HDMI card from the switched power supply and in the beginning of the error search it showed about 2,5 volts (5 volts should be sent to the HDMI card when correct).
After some other measures the voltage to the HDMI card was suddenly 5 volts...!
I assembled the amp and now it started. :)

Now there are three issues for my 5.1 setup:

1. Low volume on all channels when using the on board amplifiers. Only Sub sounds correct in volume, all other channels sound like it is a third of the volume that it used to be. Otherwise the sound produced sounds okay, just all to low. I have set +12db on all channels (except Sub since this works correct volume wise).

2. Only Pre out for Sub works, all other Pre out outputs does not work (5.1 setup). Before the issues started I used a power amp for the Front channels connected.

3. When plugging in the Audyssey microphone to perform the setup it now does not produce almost any volume for the Front L speaker when starting the setup sound so the amp says that there is no microphone connected/to low volume produced and it exits the procedure...

I have reset the receiver twice but no luck.

What can cause this issues??
Help needed badly!
I have the Service manual downloaded.

I have noticed that there are some capacitors on the Analog audio/7.1 CH Input card that has some pink color to it on the top. About 6 capacitors shows this color on top. No other capacitors what I can see has any visual damage/colors to them in the amplifier.

Thanks in advance!


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 7 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
cron
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© diyAudioProjects.com - Terms of Service - Privacy Policy