DIY Audio Projects Forum
http://diyaudioprojects.com/Forum/

Rotel RA-935BX help
http://diyaudioprojects.com/Forum/viewtopic.php?f=10&t=5417
Page 1 of 1

Author:  gregkr [ 11 Dec 2015, 21:14 ]
Post subject:  Rotel RA-935BX help

Hi.
I have a Rotel RA-935BX amp. while adjusting the Bias I accidentally slipped with the probe and shorted out pin tp2 to j36 what looks like a bridging wire, resulting in a blown fuses f901 and f902 [all positions are taken from pcb markings].
When I replace the fuses and power ON the amp the ON led flashes for a second and same fuses blow again and all goes dead. I think I have probably blown a 2SB817E transistor. But I would like to ask if there is anything I can check to see what I have damaged and how to check it. I have wiring manual but being a newbie I don't know where to start checking. I do own Fluke 112 rms multi meter and I'm not too bad with soldering iron but that is where it ends. Thanks in advance for all your help. Greg

Author:  gregkr [ 16 Dec 2015, 18:36 ]
Post subject:  Re: Rotel RA-935BX help

Hi.
Just an update the amp is up and running it was a pre-driver transistor 2SA1507 shorting out and a rectifier diode.

Page 1 of 1 All times are UTC - 6 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/