DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 30 Oct 2020, 08:35

All times are UTC - 6 hours [ DST ]

Post new topic Reply to topic  [ 1 post ] 
Author Message
PostPosted: 20 Apr 2019, 08:43 

Joined: 11 Apr 2019, 21:08
Posts: 5
I have two guitar amps that have blown is a TDA2040 in an Esteban practice amp 10 watts...(boosting it to 20 watts) the other a TDA2050 in a Marshall 30 watt amp. I would love if there were any way possible to put my MENG MiniP Music Angel hardwired place of the TDA2050. The TDA2040 is an expirement in the cheap Esteban is getting the TDA2040 in place of a TDA2030...larger capacitors, stronger transformer (slightly) and hopefully an N channel BJT or MOSFET to maybe add a saturation feature. If possible. Lots to study and any tips would be great and very much appreciated.

I thought about just building a small opamp type circuit to take the place of the TDAs in both amp. I found DIY opamps but no indication what wattage the put-out...?
If I can improve on these amps it would be great. If all I end up doing is adding a fan with larger heat sink to the TDA2050...then I will. But love to make the amp a tad better.
Thank you much.

Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 6 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 11 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© - Terms of Service - Privacy Policy