DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 17 Apr 2021, 19:25

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 1702 posts ]  Go to page Previous  1 ... 167, 168, 169, 170, 171
Author Message
PostPosted: 19 Feb 2021, 02:48 
Offline

Joined: 01 Jul 2020, 11:33
Posts: 6
Can this amp drive a planar headphone that are 25ohms 91db/1mw sensitive? Do I need to make some changes to the part values used?


Top
 Profile  
 
PostPosted: 05 Apr 2021, 12:13 
Offline

Joined: 04 Apr 2021, 08:44
Posts: 1
ILoveHiFi wrote:
Matt911 wrote:
Hi there
I am looking to use this amp as a preamp in my hifi system, this will go before my power amp of course. Will I still need the MOSTFET and lM317 as a for the current gain and constant current source if they are not directly driving the headphones?
Anything else I should look out for when using in a hifi system?
Thanks in advance! Great circuit cant wait to build! Thank you so much for all the time and effort put in!

As a pre amp, you do not need the mosfet and lm317.
You directly connect a hifi cap at where r3 4k7 joins 12au7, at the output of the cap, you put a 100k to ground instead of the 1k.
You measure output voltage dc to be zero at your pre amp before you connect to power amp.


Hi I am also keen to try this as a pre amp. Can anyone suggest a good value output capacitor to go with the modified circuit utilising a 100k please? Some values mentioned in a previous thread but I was not clear it was concerned with changing to a pre amp.
Thanks
Mark


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1702 posts ]  Go to page Previous  1 ... 167, 168, 169, 170, 171

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: Google [Bot] and 7 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© diyAudioProjects.com - Terms of Service - Privacy Policy