DIY Audio Projects Forum
 NEW  Matt presents bias and operation data for the 6V6 tube in SE operation - 6V6 Single-Ended (SE) Ultra Linear (UL) Bias Optimization.

DIY Audio Projects Forum

Welcome to the DIY Audio Projects Message Forum. Use these forums to discuss Hi-Fi audio and to share your DIY Audio Projects. Registration is free and required to post messages and view the file attachments. Registration will only take a minute and registered users do not see any advertisements. After you have completed the online registration process, check your email (including spam/junk folder) for the verification email to activate your account. New members are under moderation - so your posts will not be visible until approved by a moderator. See the Read Me 1st, Forum RULES and Forum FAQ to get started on the forum.

It is currently 25 Aug 2019, 16:15

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 132 posts ]  Go to page Previous  1 ... 10, 11, 12, 13, 14
Author Message
PostPosted: 19 Feb 2019, 04:41 
Offline

Joined: 23 Feb 2017, 02:02
Posts: 523
Personally recomend to stayway from SE as you need output capacitor, this means the speaker takes the signal from transistor then through a capacitors. Thats allot of distortion, it maybe allright if your using hifi output caps though.

You should be able to build the higra with either 4x 10000uF and trasnfomers. Otherwise SMPS
Theres feedback so it shouldn't be too much of issue.

You need to be carefull with gournding to mains with SMPS or you'll humm. Also is recomnded to put directly at output of smps to ground a 2200-4700uF capacitor so the noise is very low.
No long wires to this cap as the noise is dependant on impedance of capacitor and wiering which causes ripple for buck converters.


Top
 Profile  
 
PostPosted: 19 Mar 2019, 09:50 
Offline

Joined: 18 Dec 2018, 10:07
Posts: 1
Thanks for all inputs and thougs on this design.
I myself just started messing with amplifiers and PCBs and would like you input on my version of the Hiraga:

I'm making a SMD version of the circuit and changed some of the transistors. For the power stage I'll be using a MJL3281A / MJL1302A pair for example. The board itself is very small, only 100 X 50mm.

To power it all up I'll be using SMPS for now. Test it with 24v and 36v later.
Just waiting for the parts to arrive.

Design and project attached. Thanks in advance for the input.


This post has a file attachment. Please login or register to access it. Only Registered Members may view attached files.



Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 132 posts ]  Go to page Previous  1 ... 10, 11, 12, 13, 14

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 5 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  
DIY Tube Projects :: DIY Tube Amp Kits :: DIY Speaker Projects :: DIY Solid State Projects :: DIY IC / Op-amp Projects :: DIY Phono Projects :: DIY Cable Projects :: Hi-Fi Audio Schematics
© diyAudioProjects.com - Terms of Service - Privacy Policy